Wood Between Router Bit And Fence. I made some makeshift fences that I stuck down with double sided tape right up against the contour lines. I fist made relief holes with a drill to make the corners easier to cut.
Wood Between Router Bit And Fence My father-in-law asked a couple times if I was sure I didn't want to set my fence properly.
To position a router-table fence flush with a bit's bearing or a particular point on a bit's profile, get it close by eyeballing it, and then tighten down one end of the fence. Running Wood Between Bit and Fence.? Then position the fence flush with the bit pilot bearing. With one end locked down, pivot thefence into the bit until the bearingslips through the relief cutout andbehind the MDF face. For routing the outside edges of a work- piece then, you'll feed the wood from the right side of the table to the left side. Clamp feather boards to the fence and tabletop so they apply moderate pressure to the board. I was widening one of the grooves in such a way that the back of the bit hit the wood.
